[olug] Switch port errors...

[Brian Roberson]

send us a "show run int f0/23"

If I read the thread correctly, you are hard setting the speed duplex?


If so:

http://lists.olug.org/pipermail/olug/2010-February/027787.html





On Tue, Jul 27, 2010 at 2:46 PM, Steve Busby <steve.busby at gmail.com> wrote:

> That 2900XL is an older switch and my memory isn't what it used to be, how
> many switch ports per ASIC?  We've had ASICs go bad and it definitely
> effects all switch ports connected to that ASIC.
>
> Buz
>
> On Jul 27, 2010, at 2:36 PM, Dan Linder wrote:
>
> > On Tue, Jul 27, 2010 at 14:03, Phil Brutsche <phil at brutsche.us> wrote:
> >
> >> Replace your patch cables before you do anything else. Bad copper can
> >> cause framing errors.
> >
> >
> > Thanks - just did, but no change.
> >
> > After that I swapped to two new switch ports.  No change. :-(
> >
> > I have to save the NIC and sniffer tests for tomorrow night.
> >
> > Dan
> >
> >> My next steps:
> >>> * Replace the cables (done 2010-07-27 at 14:30)
> >>> * Move to new switch (done 2010-07-27 at 14:35)
> >>> * Use a sniffer and setup port spanning on the cablemodem side.
> >>> * Replace the firewall NIC
> >>> * Test using my old cablemodem (Surfboard SB5101) on my @Home service.
> >>> ** Move my old cablemodem to the SOHO service and see if speed changes.
> >>> * Research how to get better diagnostics out of the Surfboards.
> >>
> >
> > --
> > ***************** ************* *********** ******* ***** *** **
> > "Quis custodiet ipsos custodes?"
> >    (Who can watch the watchmen?)
> >    -- from the Satires of Juvenal
> > "I do not fear computers, I fear the lack of them."
> >    -- Isaac Asimov (Author)
> > ** *** ***** ******* *********** ************* *****************
> > _______________________________________________
> > OLUG mailing list
> > OLUG at olug.org
> > https://lists.olug.org/mailman/listinfo/olug
>
> _______________________________________________
> OLUG mailing list
> OLUG at olug.org
> https://lists.olug.org/mailman/listinfo/olug
>