[olug] Terminal Settings for Catalyst Routers

[Dan Clough]

I don't think the pinouts should be different, but then again, it is
Cisco...

Thanks for the offer, but I'll keep tinkering around and seeing what I can
dig up.  I might take you up on your offer later.

Dan

-----Original Message-----
From: olug-bounces at olug.org [mailto:olug-bounces at olug.org] On Behalf Of
Obi-Wan
Sent: Friday, May 23, 2008 9:58 AM
To: olug at OLUG.ORG
Subject: Re: [olug] Terminal Settings for Catalyst Routers

> On Fri, May 23, 2008 03:31, Dan Clough wrote:
>> I've got a Cisco Catalyst 4006 (Supervisor II) that doesn't want to play
>> nice with any terminals I've hooked up to it.
> 
> Are you using the Cisco "approved" terminal cable?

I just asked our router guy here, and he confirmed that there is a
special cable used for these.  They come with every router, but I'm
betting you got yours used.  The new ones are baby blue cables with
a female DB9 on one end and an RJ45 on the other end.  They use
standard 9600-8N1 settings.

I've got one of those cables sitting next to me that you can have
if you want it.  I'm in Lincoln, so you'll either need to arrange
transportation or pay for shipping.

-- 
Ben "Obi-Wan" Hollingsworth                             obiwan at jedi.com
   The stuff of earth competes for the allegiance I owe only to the
     Giver of all good things, so if I stand, let me stand on the
       promise that You will pull me through.  -- Rich Mullins
_______________________________________________
OLUG mailing list
OLUG at olug.org
http://lists.olug.org/mailman/listinfo/olug