[olug] Problems with setting up NICs

[Brian Roberson]

also, you need to remove the following line in your /etc/modules.conf:

> options rtl8139 irq=5,6


----- Original Message -----
From: "Phil Brutsche" <phil at giedi.obix.com>
To: <olug at bstc.net>
Sent: Thursday, October 25, 2001 5:39 PM
Subject: Re: [olug] Problems with setting up NICs


> Don Kauffman wrote:
>
> > Hello,
> >
> > I've run into a problem trying to install two DLink DFE-530TX+ NICs w/
>
> > the RealTek Chipset rtl8139
>
>        ^^^^^^^^^^^^^^^^^^^^^^^
>
> > append="eth=0,0,eth0,eth=0,0,eth1"
>   ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
>
>
> RTL8139-based ethernet cards are PCI; the IO port and IRQ are
automatically
> assigned by the BIOS at system boot.  The IO port and IRQ are also
> automatically determined by the driver when it loads.
>
> The "append=..." line in your lilo.conf is the source of your trouble.
> Remove it, re-run lilo, then reboot.
>
> The only time you need to include that line is if you're using a legacy
> kernel (ie < 2.4.x) and/or you're using ISA ethernet cards that don't have
> an ISAPNP setting.
>
>
> Phil
>
>
> -_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
>
> For help contact olug-help at bstc.net - run by ezmlm
> to unsubscribe, send mail to olug-unsubscribe at bstc.net
> or `mail olug-unsubscribe at bstc.net < /dev/null`
> (c)2001 OLUG http://www.olug.org
>
> -_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
>
>


-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_

For help contact olug-help at bstc.net - run by ezmlm
to unsubscribe, send mail to olug-unsubscribe at bstc.net
or `mail olug-unsubscribe at bstc.net < /dev/null`
(c)2001 OLUG http://www.olug.org

-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_