[olug] Fiber question for you guys

Brian Roberson roberson at bstc.net
Fri May 6 17:33:40 CDT 2016


If you can get the device/port up on the old cable, and not the new one... First thing I would do is Swap your tx and rx cables. 



> On Apr 29, 2016, at 9:33 AM, Justin Reiners <justin at hotlinesinc.com> wrote:
> 
> I currently have Cox fiber installed here at my location, It is a fiber
> drop with LC-LC connections, on single mode fiber. I purchased a couple
> cables down in Bellevue to extend the run from about 10 feet to 25. The
> existing thin, junk cable connects just fine, but both of my new cables do
> nothing when plugged in. Does anyone have any ideas? I terminate fiber to a
> cisco switch with a SMF dongle.
> 
> These cables are much nicer and heavier, but I cannot get a link light with
> them.
> 
> -- 
> 
> [image: Hotlines Inc] <http://www.partshotlines.com>
> 
> Justin Reiners / System Administrator
> 800.308.9712/ justin at hotlinesinc.com <Justin at HotlinesInc.com>
> 
> Hotlines Inc Office: 800.807.2867 / Fax: 800.211.0843
> 427 E. Kanesville Blvd. Suite 403, Council Bluffs, IA 51503
> http://www.partshotlines.com
> _______________________________________________
> OLUG mailing list
> OLUG at olug.org
> https://lists.olug.org/mailman/listinfo/olug


More information about the OLUG mailing list